RTA Pedestal Base Pole
- Height—10' to 20'
- Shaft—The shaft shall be spun tapered from all new 6063 alloy aluminum tubing and shall be heat treated to produce a T6 temper. Each shaft shall have a 6" long x 3" O.D. straight section at the top to accommodate single or multiple luminaire configurations as a slipfitter. The shaft shall be polished with fine grain aluminum oxide cloths, resulting in a high quality circumferential satin finish. After finishing, each pole shall be fully wrapped with neutral PH krinkle/kraft paper for protection in shipment.
- Pedestal Base—The pedestal base is cast from A356 alloy aluminum and is circumferentially welded to the shaft. After fabrication assembly is heat treated to a T6 temper.
- Ground Lug Provision—Each pole shall include a 5/16”-18 tapped provision for ground connector.
- Base Handhole—he clear opening and door are a trapezoid configuration. The clear opening on the vertical axis is 7". The opening on the horizontal axis is 6-1/4" at the top and 8" at the bottom.
- Anchor Bolts—Each pedestal base shall include: (3) 3/4"-10 x 17" steel fully hot dip galvanized anchor bolts each with (2) nuts and (2) flat washers.
- Special Finishes—Natural anodize, duranodic, or painted finishes may be specified as an addition to the satin brushed finish, if required. All aluminum parts and accessories shall receive a finish similar to that specified.
View Reference Numbers
Download Specification Sheet
